Microwave - Charcoal Filter Replacement: Push Access Panel for Filter

Charcoal filters are model specific, so it is important to replace the correct charcoal filter for your specific model. The charcoal filter is listed in each model's product specifications or in their Installation Instructions.

 

Replacing the Charcoal Filter on Models With the Push Access Panel for Filter

Follow the below steps to replace the charcoal filter for microwave ovens with the grille behind the microwave oven with a filter door.

 

  1. Disconnect power at the main fuse/circuit breaker or unplug.

  2. Open the microwave oven door.

  3. Push down on the two buttons on top of the filter door.

    OTR Filter Door

  4. Remove the old filter and insert the new filter. NOTE: The charcoal filter sits loosely in the filter compartment area behind the vent cover. While most are installed at an angle, some lay flat and unsecured in the filter compartment. They are designed to have freedom of movement until the vent fan is turned on, which then holds the filter in place. The filter can be smaller than the filter compartment, and may not cover the entire vent opening. This is normal.

  5. Close the filter door and close the microwave oven door.

View a short video on how to install a charcoal filter.

 

 

Note: Video may not appear if Advertising cookies are blocked. Re-enable Advertising Cookies to view videos.

 

For specific instructions on accessing and replacing the charcoal filter, consult the Owner's Manual for the specific model you own.

 

Additional Appliance Inquiries

Whatever the need, we are here to help. Considering the repair or replacement of an appliance? Please reach out to us for expert support at any time!